advanceqosa.blogg.se - Networx alarm beeping

Use the up/down arrow keys to set the hour to AM or PM hour then press * to move to minutes.

You will then see the time and date displayed with the HOURS section flashing.

4=On suppresses beeps when an RF transmission is lost.

3=On if PIN should be hidden when programming.

2=Disable LED Extinguish on this keypad.

SELECT AN OPTION: Programs special characteristics.

Prevents over-writing the custom message during keypad copy. Custom Message Lock - Enable Custom Message Lock.Clock – Enable or Disable Clock display.Custom Message – Enables or Disables Custom Message display.Enable temporary viewing of all partitions by pressing *, 1, partition number. If there is a system problem, pressing *2, shows the service menu. Will not allow the Service LED to light for any reason. Sounds a short beep to verify that the keypress was accepted. Enable panic, fire, emergency beep tone.Will not allow the keypad to display faulted or bypassed zones when the system is armed. Silences the pulsing keypad sounder for 5 seconds when a key is pressed. Silences the entry/exit sounder and chime only. Press * after enabling/disabling the desired functions.You will be presented with options, one at a time, that will enable/disable the functions for the keypad shown in the list below.Step 2 – Set keypad options (For LCD Keypads)

The keypad will automatically exit the keypad programming after this You will now enter the partition you want the keypad to be assigned to.The Instant LED will illuminate steady and the Service LED will remain flashing The Service LED and the Instant LED will flash on the keypad that you are working on Step 1 – Assign keypad number and partition You will then be asked to enter location.Total Connect 2.0 Package Monitoring Add-Ons.Central Station Alarm Monitoring Services.